That’s not a dull man that is able to do a job like that … nice work!
Thank you but it sure is not exciting
I was going to say, this is God tier DIY. I paid a plumber like $2k to install one for me.
Thank you but really its dig a lot, cut the pipe, install the rubber clamp thingies.
What for, my good dull man?
Hell yeah you did.
Shouldn’t you use a “Y fitting” at the bottom?
This tee fitting is designed to be snaked both ways
A wye fitting is designed to be snaked one direction
For example, you’d use a wye fitting after a gutter. If you’re going to snake it, it will not be in the direction of the gutter. You’re not sending the snake up the gutter. The wye would allow you to snake the portion of pipe you need easier.**
If this was in the middle of a long sewer pipe with no other clean outs near by. Then the tee is probably the better choice.
The issue is whether the crossbar of the tee is flat along the bottom or not (I can’t tell from the pic). If not, it’s going to risk causing a clog itself.
That was my thought, but apparently, this tee is designed exactly for this purpose. $40 for just the tee.
Good job! Nice work!
what fi is that pipe? Looks like black pvc water pipe.
I expected fi 110 for sewers.Its cast iron. And I assume its somewhere warm and dry if its that close to the surface.
Cast iron, at least 60 years old, could be 100. And it’s in North Florida.
What about the ballcock?!
*snkk*
